Water Eject

A low sound that pushes water out of your phone's speaker.

Turn the volume up and point the speaker down
  1. Turn the volume to maximum and disconnect Bluetooth audio.
  2. Point the speaker down and tap Eject Water.
  3. Wipe the grille dry, then tap Test the speaker.

How to Eject Water from Your Phone Speaker

  1. Disconnect Bluetooth headphones and speakers so the sound plays from the phone itself.
  2. Turn the volume all the way up and take the phone out of its case.
  3. Hold the phone with the speaker pointing down, tap Eject Water and let it run for the full 30 seconds.
  4. Wipe the grille with a dry cloth, then tap Test the speaker to hear whether it sounds clear again.

You will often see tiny droplets appear on the grille as it runs. That is the water being pushed out. Repeat if the sound is still dull.

The two modes

Steady holds a 165 hertz tone with short upward sweeps. It is the strongest option for water. Sweep glides up and down between 100 and 900 hertz, which shakes the grille across a wider range and is better for dust and lint.

What not to do with a wet phone

Do not charge it until the port is dry, do not use a hair dryer on hot, and skip the bowl of rice: it does little and can leave starch in the ports. Air and time work better.

Frequently Asked Questions

How does a sound push water out of a speaker?

A speaker makes sound by moving a thin cone back and forth. A loud, low note makes the cone move a long way with each swing, and that pumping pushes air, and any water sitting on the grille, outward. Around 165 hertz works well for phone speakers because it is low enough to move the cone a lot and high enough for a small speaker to play loudly. This is the same idea Apple Watch uses for its Water Lock feature.

How long should I run it?

One 30-second run usually clears a wet grille. If the speaker still sounds muffled or crackly, run it two or three more times, wiping the grille with a dry cloth between runs. If nothing changes after several runs, the water has probably gone deeper than the speaker and sound will not reach it.

Will this fix a phone that was dropped in water?

No. It only helps with water resting in the speaker grille and chamber, which is why a phone sounds muffled after a shower or rain. It cannot dry the inside of a phone. If your phone went fully under water, switch it off, do not charge it, dry the outside and leave it somewhere warm and airy for a day. Follow the maker's advice and get it looked at if it behaves oddly.

Is it safe for my speaker?

Yes for normal use. It plays an ordinary tone through the phone's own volume limiter, the same as loud music with heavy bass. Do not hold the speaker against your ear while it runs; at full volume it is unpleasantly loud at close range.

Does it also remove dust?

It can shake loose light dust and lint sitting on the grille, and the Sweep mode is the better choice for that. Packed-in dirt needs a soft dry brush. Do not poke the grille with a pin or blow compressed air into it.

Why can I barely hear it?

Check that the volume is at maximum and the phone is not in silent mode; on iPhone the ring switch can mute web audio. Bluetooth headphones or a speaker will take the sound instead of the phone, so disconnect them first.

More tools

Vibration MeterMeasure shaking with your phoneVocal Range TestFind your lowest and highest noteSpeaker TestCheck left, right, bass and treble